FSP offers the industrial based FSP2000-A0AGPBI 2000 Watt super high powered power supply to prevent power malfunctions during the mining process when the processor/graphics card is operating at full speed and the power is at full-load 24 hours a day.
FSP2000-A0AGPBI is an industrial level of switching power supply. The power supply comes to offer the total power capacity up to 2000 Watts, and uses unique active PFC (Power Factor Correction) circuit design with its high-load electrical components, makes it to be perfectly used in an industrial, especially high wattages environment. In addition, with its full range of input and output electrical features, the power supply is ideally the best choice for server, workstation, communication or any other automation applications to use. The product also complies with the latest safety and EMC standards, which is perfectly to meet various regulations worldwide.
- Dimensions : 200 x 150 x 86mm
- Application : For standard, advanced workstation, server and industrial power system.
- Watt : 2000W
Its full module connector design makes it easier for users to connect and disconnect cables, find the problem and save troubleshooting time when something goes wrong with the system. FSP2000-A0AGPBI is an industrial grade power supply, able to accept a 90-264 volt full-range voltage input. It has also passed high temperature and humidity tolerance, overvoltage, overcurrent and long-term operation tests to ensure that it can still provide power stably under rigorous mining environments. Also, since mining equipment needs to operate 24 hours a day without interruptions, FSP2000-A0AGPBI has 80PLUS platinum certified excellent power efficiency that can allow users to save on power bills and relatively increase the mining profit significantly.
- 80 PLUS Platinum
- Low Ripple & Noise
- Output over voltage protection
- Short circuit protection on all outputs
- Resettable power shut down
- 16 x PCI-E 6+2 PIN
- INTERNAL 12 cm fan 100% burn-in under high ambient temperature(50℃)
- Vacuum-impregnated transformer
- MTBF:100K hours at 25℃
- 100% Hi-pot tested Line input fuse protection
Due to the fact that large wattage power supplies are difficult to acquire from current markets, most miners can only adapt and buy small wattage power supplies or use two power supply units to supply power for a single host. However, since the power supplies are under heavy or partial loads for extended periods of times, not only do they have to bear the malfunction problems that may be caused due to parallel connections of the power supplies, the frequent RMA also becomes an additional cost burden. Not only that, there are frequent foreign and domestic reports of fire incidents at mining locations or burnt mining equipment due to poor power quality. Therefore as a long-term investment miner, the importance of a power supply must be considered carefully.
- Product page.
