Overclocking & Tweaking
Overclocking & Tweaking
As most of you with most videocards know, you can apply a simple series of tricks to boost the overall performance a little. You can do this at two levels, namely tweaking by enabling registry or BIOS hacks, or very simple, tamper with Image Quality. And then there is overclocking, which will give you the best possible results by far.
What do we need?One of the best tool for overclocking NVIDIA and ATI videocards is our own Rivatuner that you can download here. If you own an ATI or NVIDIA graphics card then the manufacturer actually has very nice built in options for you that can be found in the display driver properties.
Where should we go?
Overclocking: By increasing the frequency of the videocard's memory and GPU, we can make the videocard increase its calculation clock cycles per second. It sounds hard, but it really can be done in less than a few minutes. I always tend to recommend to novice users and beginners not to increase the frequency any higher then 5% of the core and memory clock. Example: If your card runs at 600 MHz (which is pretty common these days) then I suggest you don't increase the frequency any higher than 30 to 50 MHz.
More advanced users push the frequency often way higher. Usually when your 3D graphics start to show artifacts such as white dots ("snow"), you should back down 10-15 MHz and leave it at that. Usually when you are overclocking too hard, it'll start to show artifacts, empty polygons or it will even freeze. Carefully find that limit and then back down at least 20 MHz from the moment you notice an artifact. Look carefully and observe well. I really wouldn't know why you need to overclock today's tested card anyway, but we'll still show it ;)
All in all... do it at your own risk.
We used Rivatuner 2.24, our end results:
Above you can see the overclocked results for BIA: hell's highway, same image quality settings as before, in DX9 mode. Light blue is the default test session we showed you, dark blue the results with our overclocked session.
| Standard product clock frequencies | Our Overclock with Rivatuner |
| Core Clock: 1000 MHz | Core Clock: 1018 MHz |
| Shader Clock: 1000 MHz | Shader Clock: 1018 MHz |
| Memory Clock: 1000 MHz | Memory Clock: 1047 MHz |
So by overclocking we tweak out a little more performance. Though barely, the product is already clocked so intensely high that you quickly will run out of any leftover margin available to you. At 1050 MHz the GPU core would show artifacts. At 1100 MHz the memory would show white dots. As such we forfeited at 1018 MHz on the core and 1047 MHz (4188 MHz effective) on the memory.
We use Rivatuner 2.24 for overclocking by the way.
