Product Installation

 Product installation

The installation process of Enermax Aquafusion ADV 360 and 240 has been described in the included manual, but you can find it on the Enermax website. We’ll show it to you on the example of the AMD AM5 platform.

First, you should attach the radiator with the fans to the chassis.

Then you should remove the original screws and place the backplate back into position. In the next step – you must use the AM5 screws on the stock AMD backplate (after removing the stock mounting brackets). Most modern cases have a big cut-out for the CPU cooler, so there should be no need to pull the motherboard out to install the backplate (if it was removed earlier). 

Then you have to install AMD brackets on the pump’s housing. Additionally, it’s better to connect the aRGB cable to the pump’s header.

No pre-applied thermal paste exists, but you can use the provided product. Of course, you should remove the protective film from the cold plate.

The AIO pump needs to be secured by the spring screws.

Position the heatsink on the CPU and begin tightening them, alternating them with applying even pressure. You can plug the pump’s 3-pin connector into the supplied RGB Controller. You can connect the pump directly to your mainboard, but using the SATA cable is possible. Plugging the fans into the motherboard using the provided Y-splitter would be best.