Overclocking with Ivy Bridge processors

Overclocking with Ivy Bridge processors

We've mentioned at the start of this article already, if you are planning to do some overclocking with an Ivy Bridge based processor, you are so much better off with a K model processor.

Why K versions you ask? Well, the default non-K processors will be much harder to overclock. With Nehalem/Clarkdale (last generation Core i3/i5/i7) pretty much you take your base clock of 133 MHz and apply say a default multiplier of 25, that would be your 3.33 GHz processor. That base clock was capable of going so much higher, 150, 186 and when tweaked right, even over 200 MHz. So if you were able to apply a fictive 175 MHz on your base clock, you could multiply it with the limited 25 multiplier. That would get you 4375 MHz.

The new technology however has an embedded GPU / video processor merged into the very same processor die running over the same bus sharing the same L3 cache memory, things get increasingly complicated in matters of tweaking.

The new 100 MHz baseclock of Sandy/Ivy Bridge processors are harder to tweak, if you are very lucky you can get 115 MHz out of it with regular cooling, multiply that with your maximum multiplier and you'll notice that the default processor can only overclock a few hundred MHz at best. And that is why Intel introduced the K series, since it offers you an unlocked multiplier which will allow you to go much, much higher.

So please do get a 20 USD more expensive K version and in the BIOS you'll have much better tweaking options. With a proper motherboard you can now set a multiplier per core.

The procedure is as follows:

1. Leave baseclock for what it is right now
2. If optional, increase the TDP limit of your processor to 200~250 Watts
3. With a 3770K leave your base multiplier at 35
4. And now set the per core (Turbo) multiplier at a maximum of your liking, we applied an MP of 49 on all four cores
5. Increase CPU voltage, though setting AUTO might work fine, we applied 1.40V on this intel board.
6. Make sure your processor is properly cooled (we used a Noctua D12 heatpipe cooler and forced the fan to 60% RPM)
7. Save and Exit BIOS / UEFI

So these settings allow us to work at a baseline clock of roughly 3500 MHZ, which helps us in IDLE power consumption. However, once the processor gets a kick in the proverbial nuts, it can turbo any or all cores towards that multiplier of 49 times that 100 MHz baseclock frequency, that's a 4900 MHz configuration setup in less than a minute.

This is all done on the reference Intel board. We have no doubt that ASUS, MSI, Gigabyte, ECS etc. will all reach higher numbers. But not bad eh?

Let's have a look at a Prime95 stress test with all four cores active and stressed at 4900 MHz.

This entire overclock will be integrated into the test sessions. So all benchmarks will have these overclocked results embedded into our article. The K editions are going to kick ass and absolutely will offer the most bang for buck, to the enthusiast crowd of course.