This new coolbits registry hack has some new items in it that are interesting for sure. This .reg file was created and thus is courtesy by rewt, he did a nice job for sure.
FAQ:
--------
Q. I dont see the temperature settings, is this due to my card?
A. The temp settings panel is only available with cards equipped with thermal sensors. Some cards that I know of have temp sensors are 5700 Ultra, 5800 Ultra, 5900 non-Ultra and Ultra, and 5950 ultra. But really it all comes down to the manufacturer. I have seen some 5700 and 5900 without temp sensor, but mainly the cheaper XT/LX/SE versions.
Q. The Fan always on doesn`t seem to work
A. The 'fan always on' option is for cards with the OTES (i.e. 5800U) or similar cooling system in which shuts off in 2d mode. It will force fan on even in 2D mode. Of course this means the fans on the hs/f be designed such a way that this option can work.
Q. I thought it enabled Opengl 2.0. It doesn't though.
A. OpenGL Shading Language 2.0 can only be enabled on 55.xx and higher Forceware drivers. It had not yet been implemented in older Detonator or pre 55 Forceware drivers.
Q. Where is the application profiles page?
A. It has been disabled to allow for OpenGL and Direct3d tabs. You can re-enable the application profiles page by changing its respective value to 1 in the coolbits file.
If you experience any minor problems, simply uninstall/reinstall your display driver. I would recommend using Driver Cleaner as well, especially when switching driver versions.
Unpack the achive (self extracting) and then in the setup directory simply click on the .reg file. To get to these options simply right-click on your desktop and go to 'NVIDIA Analog Display' (Win XP/2003). For Win 2000 and lower you may need to get to the Nvidia Control Panel the old way. Right click desktop > Properties > Settings > Advanced > GeForce xxxx
*NOTE: Coolbits 2 is not fully compatible with driver versions older than 55.xx. If you do happen to run this tweak with drivers older than 55.xx you will more than likely get errors at startup! To enable full compatibility, you must disable the options that are causing issues with your current setup.
